| Internal fuse |
T 6.3 A / 250 VAC |
| Required backup fusing |
An external DC fuse is required for the DC input voltage. |
| Recommended backup fusing |
16 A (for USA/Canada: 15 A) |
| Signaling |
Optical status indication (DC OK; load; warning and error states) |
| Digital signal input and output (DI/DO) |
| Communication |
Communication interface, can be used with WAGO USB Communication Cable (750-923) or IO-Link Communication Module (2789-9080) or Modbus RTU Communication Module (2789-9015) |
| Phases |
1 |
| Nominal input voltage Ui nom |
1 x AC 100 … 240 V |
| Input voltage range |
AC 90 … 264 V; DC 130 … 240 V |
| Nominal mains frequency range |
47 … 63 Hz; 0 Hz |
| Input current Ii |
≤ 1 A (240 VAC; Nominal load); ≤ 1.8 A (100 VAC; Nominal load) |
| Inrush current |
≤ 9 A (after 1 ms) |
| Power factor correction (PFC) |
Active |
| Mains failure hold-up time |
≥ 20 ms (230 VAC) |
| Nominal output voltage Uo nom |
DC 24 V (SELV) |
| Output voltage range |
DC 24 … 28 V (adjustable) |
| Default setting |
DC 24 V |
| Nominal output current Io nom |
5 A (24 VDC) |
| Nominal output power |
120 W |
| Control deviation |
≤ 1 % |
| Residual ripple |
≤ 70 mV (peak-to-peak) |
| Current limitation |
1.1 x Io nom (typ.) |
| Overload behavior |
TopBoost/PowerBoost/Time-limited constant current mode (other overload behaviors can be set) |
| PowerBoost |
DC 7.5 A (5 s) |
| TopBoost |
up to 600 % |
| Power loss Pl |
≤ 1 W (Standby); ≤ 2 W (No load); ≤ 10 W (230 VAC; Nominal load) |
| Efficiency (typ.) |
93.8 % (230 VAC; 5 A; 25 °C) |
| Isolation voltage (pri.-sec., AC) |
3,510 V |
| Isolation voltage (pri.-GND, AC) |
2,200 V |
| Isolation voltage (Sec.-GND) |
DC 0.5 kV |
| Isolation voltage (Sec.-Signal) |
DC 0.5 kV |
| Protection class |
I |
| Protection type |
IP20 (per EN 60529) |
| Resistance to reverse feed |
≤ DC 35 V |
| Overvoltage category |
III (≤ 2000 m a. s.l.); II (> 2000 m a. s.l.) |
| Pollution degree |
2 |
| Transient suppression (primary) |
Yes |
| Overvoltage protection; secondary |
Internal protective circuit |
| ≤ 35 VDC (in the event of a fault) |
| Short-circuit-protected |
Yes |
| Open-circuit-proof |
Yes |
| Parallel operation |
Yes |
| Series operation |
Yes |
| MTBF |
> 1,000,000 h (per IEC 61709) |
